Yang Chun YD50 Series 24V / 12V high-power DC pump, self-absorption fast, high head, large flow, small size, easy to carry Suitable for use in a variety of field use DC battery to transport oil products of large machinery transport diesel, kerosene work such as bulldozers , Dug Horie loader and other heavy machinery and equipment oil, unloading. Mining machinery, agricultural machinery, all those who can not refuel at the regular gas station all the vehicles and fuel supply needs of mining equipment, construction machinery, and no AC so-called wet electricity supply situation, simply by the pump and car batteries or suitable Battery power will continue to influx to ensure that your vehicle will never go without helpless courage, the machine is not explosion-proof, non-gasoline, alcohol, methane, chemical and water extraction.
Vane pump, mechanical seal, safe and reliable
Cast iron pump body, anti-corrosion coating
Built-in vacuum check valve to better protect the motor
High temperature copper motor, protection class IP 5
The machine has positive and negative switch, suitable for more oil out of a health return to the drum
Built-in safety valve relief valve (commonly known as bypass valve), scientifically reasonable and safe, constant pressure, no need to set the return flow of thin tubes, guns are not afraid of pump, you can easily move, you can car, you can pumping barrels, you can Fixed installation in the wall and so on!
Machine configuration: a filter, the interface of two, four screws, four nuts, a small horn within the six-angle, stainless steel card two, a certificate of competency.
1: Before using the power supply, make sure that the power supply voltage is consistent with the standard power supply.
This machine is not explosion-proof, can not be pumping flammable and explosive chemicals
2: + 5% voltage tolerance, DC 12V or 24V, pay attention to +, - very.
Such as: the voltage is consistent with the positive and negative is correct;
Do not use over voltage. Otherwise, the motor will burn out, and if the direct current is directly connected to the 220V power supply, the machine may explode. People may be injured. Please make sure the power voltage before use.
3, the first time the pump, please inject a small amount of oil in the pump chamber, and then follow the direction of the arrow out of oil into the oil.
4, into the pipe and fittings, must not leak, to ensure suction. The company must be equipped with filter at the end of the valve, to ensure that the oil clean.
5, the product into the oil port must take over the filter; to prevent foreign matter into the pump affect the quality of use, and to regularly remove the filter surface dirt, mesh surface can not be wrapped with thin stockings too thin, only the end of the tubing with stockings Package filtration again. Otherwise, the filter will be blocked and the flow will be reduced and the pump will be damaged.
6, continuous working time do not exceed "twenty" minutes, so as not to affect the service life; (especially the DC pump)
7, leaves are vulnerable products, not within the scope of the warranty!
Man-made damage or wrongly connected positive and negative motor damage caused is not covered by the warranty! (Red line connected to the positive black line then negative)
8, 500 hours after running the pump, you should ask professionals to maintain.
Not empty machine operation, non-riot models